GN 808.2 universal joint shafts with friction bearing do not only bridge the misaligenment of two shafts, but at the same time they offer an added length compensation, which, depending on the overall lenght l1, enables a corresponding extension dimension l2. The power transmission is achieved by two DIN 808 universal joints (type EG), a spline shaft and a sliding sleeve.
It is important to check the accuracy when connecting the spline shaft to the sliding sleeve, the markings -> <- have to be opposite to each other. Any kind of misconnection leads to an irregular output and to a quick abrasion.
Diifferent lengths l1 - l2
Bores without keyway
Bores with square
Bores with hex
Additional bores or d2 with different bores
Version in stainless steel
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.683 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 1-800-397-6993
